26-12
Complete the following tasks to configure IRF:
Task Remarks
Configuring IRF Ports Required
Setting a Member ID for a Device Optional
Specifying a Priority for an IRF Member Required
Specifying the Preservation Time of IRF Bridge
MAC Address
Optional
Enabling Auto Upgrade of Boot Files Optional
IRF Configuration
Setting the Delay Time for the Link Layer to
Report a Link-Down Event
Optional
Connect the physical IRF ports of devices by using IRF cables (a ring connection is recommended)
or fibers, and then power on the devices.
Logging In to the Master Required
Logging In to an IRF
Logging In to a Slave Optional
IRF Configuration
Configuring IRF Ports
IRF can be enabled on a device only after the IRF ports are bound with physical IRF ports).
For how to bind the IRF port and physical IRF port(s) on an Switch 4210G series, see
Correspondence
between an IRF port and a physical IRF port
.
Follow these steps to configure IRF ports
To do… Use the command… Remarks
Enter system view system-view —
Bind physical IRF ports to an
IRF port, and enable IRF on
the current device
irf member member-id irf-port
irf-port-id port port-list
Required
By default, no IRF port is
configured.
To Next Page
Loading...
