EasyManua.ls Logo

3Com 4210G Series - Configuring TCP Optional Parameters

3Com 4210G Series
1133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11-3
[SwitchA-Vlan-interface3] ip address 1.1.1.2 24
[SwitchA-Vlan-interface3] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 2.2.2.2 24
# Enable VLAN-interface 2 to forward directed broadcasts.
[SwitchA-Vlan-interface2] ip forward-broadcast
z Configure Switch B
# Enable Switch B to receive directed broadcasts.
<SwitchB> system-view
[SwitchB] ip forward-broadcast
# Configure a static route to the host.
[SwitchB] ip route-static 1.1.1.1 24 2.2.2.2
# Configure an IP address for VLAN-interface 2.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 2.2.2.1 24
After the above configurations, if you ping the subnet broadcast address (2.2.2.255) of VLAN-interface
2 of Switch A on the host, the ping packets can be received by VLAN-interface 2 of Switch B. However,
if you disable the ip forward-broadcast command, the ping packets cannot be received by the
VLAN-interface 2 of Switch B.
Configuring TCP Optional Parameters
TCP optional parameters that can be configured include:
z synwait timer: When sending a SYN packet, TCP starts the synwait timer. If no response packet is
received within the synwait timer interval, the TCP connection cannot be created.
z finwait timer: When a TCP connection is changed into FIN_WAIT_2 state, the finwait timer is
started. If no FIN packets is received within the timer interval, the TCP connection will be
terminated. If a FIN packet is received, the TCP connection state changes to TIME_WAIT. If a
non-FIN packet is received, the system restarts the timer upon receiving the last non-FIN packet.
The connection is broken after the timer expires.
z Size of TCP receive/send buffer
Follow these steps to configure TCP optional parameters:
To do… Use the command… Remarks
Enter system view system-view
Configure the TCP synwait
timer
tcp timer syn-timeout
time-value
Optional
75 seconds by default.
Configure the TCP finwait timer
tcp timer fin-timeout
time-value
Optional
675 seconds by default.
Configure the size of TCP
receive/send buffer
tcp window window-size
Optional
8 KB by default.

Table of Contents

Other manuals for 3Com 4210G Series

Related product manuals