3Com 4210G Series - Configuring the Line Rate; Configuration Procedure; Configuration Example; Displaying and Maintaining Traffic Policing, GTS, and Line Rate

4-7
[Sysname-GigabitEthernet1/0/1] qos gts queue 1 cir 512
Configuring the Line Rate
Configuration Procedure
Follow these steps to configure the line rate:
To do… Use the command… Remarks
Enter system view system-view —
Enter
interface
view
interface interface-type
interface-number
Enter
interface
view or
port group
view
Enter port
group
view
port-group manual
port-group-name
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port
group.
Configure the outbound
line rate for the
interface/port group
qos lr outbound cir
committed-information-rate [ cbs
committed-burst-size ]
Required
Configuration Example
Limit the outbound line rate of GigabitEthernet 1/0/1 to 512 kbps.
# Enter system view.
<Sysname> system-view
# Enter interface view.
[Sysname] interface gigabitethernet 1/0/1
# Limit the outbound line rate of GigabitEthernet 1/0/1 to 512 kbps.
[Sysname-GigabitEthernet1/0/1] qos lr outbound cir 512
Displaying and Maintaining Traffic Policing, GTS, and Line Rate
On the Switch 4210G series, you can configure traffic policing in policy-based approach. For related
displaying and maintaining commands, refer to
Displaying and Maintaining QoS Policies.
To do… Use the command… Remarks
Display interface GTS
configuration information
display qos gts interface
[ interface-type
interface-number ]
Available in any view
Display interface line rate
configuration information
display qos lr interface
[ interface-type
interface-number ]
Available in any view