3Com 5500-EI PWR - Page 10

1-9
View
Available
operation
Prompt example Enter method Quit method
User interface
view
Configure user
interface
parameters
[Sysname-ui-aux0]
Execute the
user-interface
command in
system view.
FTP client
view
Configure FTP
client parameters
[ftp]
Execute the ftp
command in user
view.
SFTP client
view
Configure SFTP
client parameters
sftp-client>
Execute the sftp
command in
system view.
MST region
view
Configure MST
region parameters
[Sysname-mst-regi
on]
Execute the stp
region-configurati
on command in
system view.
Cluster view
Configure cluster
parameters
[Sysname-cluster]
Execute the
cluster command
in system view.
Configure the RSA
public key for SSH
users
[Sysname-rsa-publ
ic-key]
Execute the rsa
peer-public-key
command in
system view.
Public key
view
Configure the RSA
or DSA public key
for SSH users
[Sysname-peer-pu
blic-key]
Execute the
public-key peer
command in
system view.
Execute the
peer-public-ke
y end
command to
return to system
view.
Edit the RSA public
key for SSH users
[Sysname-rsa-key-
code]
Public key
editing view
Edit the RSA or
DSA public key for
SSH users
[Sysname-peer-ke
y-code]
Execute the
public-key-code
begin command in
public key view.
Execute the
public-key-cod
e end
command to
return to public
key view.
DHCP
address pool
view
Configure DHCP
address pool
parameters
[Sysname-dhcp-po
ol-a123]
Execute the dhcp
server ip-pool
command in
system view.
Execute the
quit command
to return to
system view.
Execute the
return
command to
return to user
view.
PIM view
Configure PIM
parameters
[Sysname-pim]
Execute the pim
command in
system view.
If multicast routing
is not enabled, you
should first execute
the multicast
routing-enable
command.
RIP view
Configure RIP
protocol
parameters
[Sysname-rip]
Execute the rip
command in
system view.
Execute the
return
command to
return to user
view.