3Com 5500-EI PWR - Configuring a Multicast MAC Address Entry

4
To do... Use the command... Remarks
Clear multicast forwarding
entries and, with statistics
specified, the corresponding
statistics information
reset multicast forwarding-table
[ statistics ] { all | { group-address [ mask
{mask | mask-length } ] | source-address
[ mask { mask |mask-length } ] |
incoming-interface interface-type
interface-number } * }
Clear routing entries in the core
multicast routing table
reset multicast routing-table { all |
{ group-address [ mask { mask
|mask-length } ] | source-address [ mask
{ mask | mask-length } ] |
{ incoming-interface interface-type
interface-number } } * }
Use the reset
commands in
user view.
Configuring a Multicast MAC Address Entry
In Layer 2 multicast, the system can add multicast forwarding entries dynamically through a Layer 2
multicast protocol. Alternatively, you can statically bind a port to a multicast MAC address entry by
configuring a multicast MAC address entry manually.
Generally, when receiving a multicast packet for a multicast group not yet registered on the switch, the
switch will flood the packet within the VLAN to which the port belongs. You can configure a static
multicast MAC address entry to avoid this.
Follow these steps to configure a multicast MAC address entry in system view:
To do... Use the command... Remarks
Enter system view
system-view
—
Create a multicast MAC
address entry
mac-address multicast
mac-address interface
interface-list vlan vlan-id
Required
The mac-address argument
must be a multicast MAC
address.
Follow these steps to configure a multicast MAC address entry in Ethernet port view:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Create a multicast MAC
address entry.
mac-address multicast
mac-address vlan vlan-id
Required
The mac-address argument
must be a multicast MAC
address.