3-5
[Sysname-ui-vty0] authentication-mode none
# Specify commands of level 2 are available to users logging in to VTY 0.
[Sysname-ui-vty0] user privilege level 2
# Configure Telnet protocol is supported.
[Sysname-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[Sysname-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Sysname-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[Sysname-ui-vty0] idle-timeout 6
Telnet Configuration with Authentication Mode Being Password
Configuration Procedure
Follow these steps to configure Telnet with the authentication mode being password:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter one or more VTY
user interface views
user-interface vty
first-number [ last-number ]
—
Configure to authenticate
users logging in to VTY
user interfaces using the
local password
authentication-mode
password
Required
Set the local password
set authentication
password { cipher | simple }
password
Required
Configure the command
level available to users
logging in to the user
interface
user privilege level level
Optional
By default, commands of level 0 are
available to users logging in to VTY
user interface.
Configure the protocol to
be supported by the user
interface
protocol inbound { all | ssh |
telnet }
Optional
By default, both Telnet protocol and
SSH protocol are supported.
Set the commands to be
executed automatically
after a user login to the
user interface successfully
auto-execute command text
Optional
By default, no command is executed
automatically after a user logs into the
user interface.
Make terminal services
available
shell
Optional
By default, terminal services are
available in all user interfaces.
To Next Page
Loading...
