3Com 5500-EI PWR - Page 42

3-9
Note that if you configure to authenticate the users in the scheme mode, the command level available to
the users logging in to the switch depends on the user privilege level level command and the
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] } command, as listed in
Table
3-4.
Table 3-4 Determine the command level when users logging in to switches are authenticated in the
scheme mode
Scenario
Authentication
mode
User type Command
Command
level
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
Level 0
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
Determined by
the service-type
command
The user privilege level level
command is executed, and the
service-type command does not specify
the available command level.
Level 0
VTY users that
are
AAA&RADIUS
authenticated or
locally
authenticated
The user privilege level level
command is executed, and the
service-type command specifies the
available command level.
Determined by
the service-type
command
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
Level 0
The user privilege level level
command is executed, and the
service-type command does not specify
the available command level.
VTY users that
are authenticated
in the RSA mode
of SSH
The user privilege level level
command is executed, and the
service-type command specifies the
available command level.
Determined by
the user
privilege level
level command
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
Level 0
authentication-m
ode scheme
[ command-auth
orization ]
VTY users that
are authenticated
in the password
mode of SSH
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
Determined by
the service-type
command