3Com 5500-EI PWR - Displaying Source IP Address Configuration

7-2
To do… Use the command… Remarks
a Telnet client
telnet { source-ip ip-address | source-interface
interface-type interface-number }
z The IP address specified is that of a Layer 3 interface of the local device. Otherwise, the system
prompts configuration failure.
z The source interface specified must exist. Otherwise, the system prompts configuration failure.
z Configuring the source interface of Telnet service packets equals configuring the IP address of this
interface as the source IP address of the Telnet service packets.
z If a source IP address (or source interface) is specified, you need to make sure that the route
between the IP addresses (or interface) and the Telnet server is reachable.
Displaying Source IP Address Configuration
To do… Use the command… Remarks
Display the source IP address
configured for the Telnet
service packets
display telnet source-ip
Available in any view