2-21
Follow these steps to configure WINS servers for the DHCP client:
To do… Use the command… Remarks
Enter system view
system-view
—
interface interface-type interface-number
dhcp server nbns-list ip-address&<1-8>
Configure the
current
interface
quit
Configure
WINS server
addresses for
DHCP clients
Configure
multiple
interfaces in
system view
dhcp server nbns-list ip-address&<1-8>
{ interface interface-type interface-number [ to
interface-type interface-number ] | all }
Required
By default, no
WINS server
address is
configured.
interface interface-type interface-number
dhcp server netbios-type { b-node | h-node |
m-node | p-node }
Configure the
current
interface
quit
Configure a
NetBIOS
node type for
DHCP clients
Configure
multiple
interfaces in
system view
dhcp server netbios-type { b-node | h-node |
m-node | p-node } { interface interface-type
interface-number [ to interface-type
interface-number ] | all }
Required
By default, no
NetBIOS node
type is specified.
If b-node is specified for the client, you don’t need to specify any WINS server address.
Configuring BIMS Server Information for the DHCP Client
A DHCP client performs regular software update and backup using configuration files obtained from a
BIMS server. Therefore, the DHCP server needs to offer DHCP clients the BIMS server IP address, port
number, shared key from the DHCP address pool.
Follow these steps to configure BIMS server information for the DHCP client:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the BIMS server
information to be assigned to
the DHCP client
dhcp server bims-server ip
ip-address [ port port-number ]
sharekey key { interface interface-type
interface-number [ to interface-type
interface-number ] | all }
Required
By default, no BIMS
server information is
configured.
Configuring Option 184 Parameters for the Client with Voice Service
For details about Option 184, refer to Configuring Option 184 Parameters for the Client with Voice
Service
.
To Next Page
Loading...
