8-5
To do… Use the command… Remarks
Create a basic ACL or
enter basic ACL view
acl number acl-number [ match-order
{ auto | config } ]
As for the acl number
command, the config
keyword is specified by
default.
Define rules for the ACL rule [ rule-id ] { deny | permit } [ rule-string ] Required
Quit to system view
quit
—
Apply the ACL while
configuring the SNMP
community name
snmp-agent community { read | write }
community-name [ acl acl-number |
mib-view view-name ]*
Apply the ACL while
configuring the SNMP
group name
snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ] [ acl acl-number ]
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number ]
Apply the ACL while
configuring the SNMP
user name
snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl acl-number ]
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode { des56 |
aes128 } priv-password ] ] [ acl
acl-number ]
Required
According to the SNMP
version and configuration
customs of NMS users,
you can reference an ACL
when configuring
community name, group
name or username. For
the detailed configuration,
refer to SNMP-RMON for
more.
Configuration Example
Network requirements
Only SNMP users sourced from the IP addresses of 10.110.100.52 are permitted to log in to the switch.
Network diagram
Figure 8-2 Network diagram for controlling SNMP users using ACLs
Switch
10.110.100.46
Host A
IP network
Host B
10.110.100.52
Configuration procedure
# Define a basic ACL.
<Sysname> system-view
To Next Page
Loading...
