1-11
z You need to enable the XRN automatic fabric function on all the devices including the newly added
device in the fabric to enable the newly added device to download software and discovery
neighbors and thus be added to the fabric normally.
z After you configure the XRN automatic fabric function on Slave, execute the save command to
save the configurations as soon as possible. Otherwise, the device may synchronize the
configurations from Master and restart repeatedly because the configurations on the device are
lost after the device automatically downloads the software and restarts.
Displaying and Maintaining XRN Fabric
To do… Use the command… Remarks
Display the information about an
XRN fabric
display xrn-fabric [ port ]
Display the topology information of
an XRN fabric
display ftm { information |
topology-database }
Available in any view
Clear the FTM statistics
reset ftm statistics
Available in user view
XRN Fabric Configuration Example
Network Requirements
Configure unit ID, unit name, XRN fabric name, and authentication mode for four switches to enable
them to form an XRN fabric as shown in
Figure 1-4.
The configuration details are as follows:
z Unit IDs: 1, 2, 3, 4
z Unit names: unit 1, unit 2, unit 3, unit 4
z Fabric name: hello
z Authentication mode: simple password
z Password: welcome
To Next Page
Loading...
