3Com 5500-EI PWR - Page 9

1-8
Table 1-1 lists the CLI views provided by the 3com switch 5500-EI, operations that can be performed in
different CLI views and the commands used to enter specific CLI views.
Table 1-1 CLI views
View
Available
operation
Prompt example Enter method Quit method
User view
Display operation
status and
statistical
information of the
switch
<Sysname>
Enter user view
once logging into
the switch.
Execute the
quit command
to log out of the
switch.
System view
Configure system
parameters
[Sysname]
Execute the
system-view
command in user
view.
Execute the
quit or return
command to
return to user
view.
100 Mbps Ethernet
port view:
[Sysname-Etherne
t1/0/1]
Execute the
interface ethernet
command in
system view.
Ethernet port
view
Configure Ethernet
port parameters
1000 Mbps
Ethernet port view:
[Sysname-Gigabit
Ethernet1/0/25]
Execute the
interface
gigabitethernet
command in
system view.
Aux1/0/0 port
(the console
port) view
The 3com switch
5500-EI does not
support
configuration on
port Aux1/0/0
[Sysname-Aux1/0/
0]
Execute the
interface aux 1/0/0
command in
system view
VLAN view
Configure VLAN
parameters
[Sysname-vlan1]
Execute the vlan
command in
system view.
VLAN
interface view
Configure VLAN
interface
parameters,
including the
management
VLAN parameters
[Sysname-Vlan-int
erface1]
Execute the
interface
Vlan-interface
command in
system view.
Loopback
interface view
Configure loopback
interface
parameters
[Sysname-LoopBa
ck0]
Execute the
interface
loopback
command in
system view.
NULL
interface view
Configure NULL
interface
parameters
[Sysname-NULL0]
Execute the
interface null
command in
system view.
Local user
view
Configure local
user parameters
[Sysname-luser-us
er1]
Execute the
local-user
command in
system view.
Execute the
quit command
to return to
system view.
Execute the
return
command to
return to user
view.