1-4
Task Remarks
Enabling the VLAN-VPN Feature for a Port Required
Configuring the TPID Value for VLAN-VPN Packets on a Port Optional
Configuring the Inner-to-Outer Tag Priority Replicating and Mapping Feature Optional
Enabling Transparent IGMP Message Transmission on a VLAN-VPN Port Optional
Caution:
As XRN fabric is mutually exclusive with VLAN-VPN, make sure that XRN fabric is disabled on the
switch before performing any of the configurations listed in the above table. For information about XRN
fabric, refer to XRN Fabric Configuration in this manual.
Enabling the VLAN-VPN Feature for a Port
Follow these steps to enable the VLAN-VPN feature for a port:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the VLAN-VPN
feature on the port
vlan-vpn enable
Required
By default, the VLAN-VPN feature
is disabled on a port.
Configuring the TPID Value for VLAN-VPN Packets on a Port
For your device to correctly identify the VLAN tagged frames from the public network, make sure that
the TPID you will use is the same as that used on the peer device in the public network.
Follow these steps to configure the TPID for VLAN-VPN packets on a port:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the TPID value on the
port
vlan-vpn tpid value
Required
Do not set the TPID value to any of
the protocol type values listed in
Table 1-1.
For Switch 5500-EI series
switches, the TPID defaults to
0x8100.
To Next Page
Loading...
