1-8
To do… Use the command… Remarks
Enable history record
history-record enable
Optional
By default, history record is not enabled.
Configure the retaining
time of history record
history keep-time keep-time
Optional
By default, the retaining time of history
record is 120 minutes.
Configure statistics
interval and the
maximum number of
retained statistics
information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120
minutes and up to two pieces of statistics
information can be retained.
Configure the retaining
time of statistics
information
statistics keep-time
keep-time
Optional
By default, the retaining time of statistics
information is 120 minutes.
Configure test start
time and lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime
Optional
By default, no test start time and lifetime
is configured.
Enable routing table
bypass
sendpacket passroute
Optional
By default, routing table bypass is
disabled.
Set the maximum
number of concurrent
tests
remote-ping-agent
max-requests number
Optional
By default, five concurrent tests are
allowed.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Start the test
test-enable
Required
Display test results
display remote-ping results
[ admin-name operation-tag ]
Required
You can execute the command in any
view.
3) Configuring FTP test on remote-ping client
Follow these steps to configure FTP test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the remote-ping
client function
remote-ping-agent enable
Required
By default, the remote-ping client
function is disabled.
Create a remote-ping
test group and enter its
view
remote-ping
administrator-name
operation-tag
Required
By default, no test group is configured.
Configure the
destination IP address
destination-ip ip-address
Required
By default, no destination address is
configured.
To Next Page
Loading...
