32 CHAPTER 3: SETTING UP FOR MANAGEMENT
Setting Up
Overview
This section gives an overview of what you need to do to get your Switch
set up and ready for management when it is in its default state. The
whole setup process is summarized in Figure 11
. Detailed procedural
steps are contained in the sections that follow. In brief, you need to:
■ Configure IP information manually for your Switch or view the
automatically configured IP information
■ Prepare for your chosen method of management
Figure 11 Initial Switch Setup and Management Flow Diagram
Plug and Play Setup
Initial IP Information Setup
Feature Management
Power Up the Switch.
IP Information is automatically configured via
DHCP
See page 33
Do you want to manually
configure the IP information?
Connect to the con-
sole port and use the
Command Line Inter-
face.
See page 35
How do you want to manage your Switch? See
SNMP
See page 47
Command Line Interface
Connect via the
console port.
See page 44
Web Interface
Connect over the
network via Telnet.
See page 44
Connect over the
network.
See page 47
How do you want to view the automatically
configured IP information?
How do you want to connect to the Switch?
Connect to a front panel port
and use the Web Interface or
Command Line
Interface.
See page 35
Use 3Com Network
Director (3ND).
See page 42
Connect to the console
port and use the
Command Line
Interface.
See page 42
Yes
No
DUA1715-0AAA02.book Page 32 Wednesday, March 23, 2005 11:17 AM
To Next Page
Loading...
