Manually Configuring IP Information 37
2 At the login and password prompts, enter admin as your user name and
press Return and at the password prompt press Return again. If you have
logged on correctly, <5500-xx> should be displayed (where xx is either
SI or EI) as shown in Figure 13
.
Once you have logged in you will automatically be in User View.
Figure 13 User View Login
3 Enter the system-view command and Enter.
To confirm that you are in the System View, the following should be
displayed:
[5500-xx]
(where xx is either SI or EI)
4 Enter interface vlan 1 and Enter.
5 Enter the IP address and subnet mask for the Switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
and Enter
.
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is
the subnet mask of the Switch)
6 Select the quit command and enter the default gateway for the Switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
7 From the User View, enter the save command to save the configuration
to your Switch as the configuration is not saved automatically when the
Switch is powered down.
DUA1715-0AAA02.book Page 37 Wednesday, March 23, 2005 11:17 AM
To Next Page
Loading...
