EasyManua.ls Logo

3Com 5500-EI PWR - Page 58

3Com 5500-EI PWR
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58 CHAPTER 4: CREATING AN XRN STACKING FABRIC
Table 14 SuperStack 4 Switch 5500 Support for XRN Distributed Fabric
1 Ensure that the Switch units that you wish to interconnect have the latest
software agent installed. You can use the display version
command to check this.
2 Enable the ‘up port’ and the ‘down port’ on each Switch (see Ta b le 14
) to
operate in Fabric mode using the following CLI command. From the
System View enter fabric-port gigabitethernet 1/0/51
enable, for example.
As with all Switch 5500 CLI commands, the format for entering a
command that is port specific is x/y/z, where x = unit number, y = module
number (in the case of the Switch 5500 this will always be 0), z = port
number.
3 Connect the Fabric-enabled ‘up’ port on one Switch 5500 unit to the
Fabric-enabled ‘down’ port on another Switch 5500 unit using the
appropriate connection method for your Switch as detailed in Tab l e 14
.
4 To create a fully resilient Fabric: enable the spare Fabric ports on the
top-most and bottom-most units in the Fabric as described in the
previous steps. Then insert a cable into these two Fabric ports to create a
link between the top-most and bottom-most units in the Fabric, as shown
in Figure 17
on page 60.
This ensures that in the event of a unit failure within the Fabric, the Fabric
will continue working and no “Fabric split” will occur.
5 Save all configuration settings. From the User View, enter the save
command to save the configuration to your Switch.
Switch Port used XRN support
Switch 5500-SI 28-Port
(3C17151-91)
Ports 27 (up port) and 28
(down port) using a
1000 Mbps SFP transceiver
Only supports DDM
*
* Distributed Device Management
Switch 5500-SI 52-Port
(3C17152-91)
Ports 51 (up port) and 52
(down port) using a
1000 Mbps SFP transceiver
Only supports DDM*
Switch 5500-EI 28-Port
(3C17161-91)
Ports 27 (up port) and 28
(down port) using a
1000 Mbps SFP transceiver
Full XRN functionality
Switch 5500-EI 52-Port
(3C17162-91)
Ports 51 (up port) and 52
(down port) using a
1000 Mbps SFP transceiver
Full XRN functionality
DUA1715-0AAA02.book Page 58 Wednesday, March 23, 2005 11:17 AM

Table of Contents

Other manuals for 3Com 5500-EI PWR

Related product manuals