1-9
View
Any view
Parameters
None
Description
Use the display diagnostic-information command to display or save the running statistics of the
system function modules. If you choose to save the statistics, the system will save the statistics to a file
with the extension .diag in the Flash memory.
Examples
# Save the running statistics of the system function modules to the file default.diag.
<Sysname> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
Diagnostic-information is saved to Flash or displayed(Y=save N=display)?[Y/N]y
Please input the file name(*.diag)[flash:/default.diag]:
The file is already existing, overwrite it? [Y/N]y
% Output information to file: flash:/default.diag.
Please wait......
After saving the information, you can use the more default.diag command in user view to view the
contents of the file (default.diag) with the Page Up and Page Down keys.
# Display the running statistics of the system function modules.
<Sysname> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
Diagnostic-information is saved to Flash or displayed(Y=save N=display)?[Y/N]n
-------------------- display version --------------------
……
<Omitted>
terminal debugging
Syntax
terminal debugging
undo terminal debugging
View
User view
Parameters
None
Description
Use the terminal debugging command to enable terminal display for debugging information.
To Next Page
Loading...
