3Com 5500-SI - Page 6

3Com Switch 5500 Family
Quick Reference Guide
clock datetime
Use the clock datetime command to set the current system time and date.
User view
clock summer-time
Use the clock summer-time command to set the name, time range and offset of the daylight saving time.
User view
clock timezone
Use the clock timezone command to set local time zone information.
User view
close
Use the close command to disconnect FTP client side from FTP server side without exiting FTP client side
view so that you terminate the control connection and data connection with the remote FTP server at the
same time.
FTP Client view
cluster
Use the cluster command to enter cluster view.
System view
cluster enable
Use the cluster enable command to enable the cluster function on a switch.
System view
cluster-mac
Use the cluster-mac command to configure a multicast MAC address for cluster management. Run this
command only on the management device.
Cluster view
cluster-mac syn-interval
Use the cluster-mac syn-interval command to set the interval for the management device to send
multicast packets. This command can be executed on the management device only.
Cluster view
cluster switch-to
Use the cluster switch-to command to switch between the management device and member devices
for configuration and management.
User view
command-privilege level
Use the command-privilege level command to configure the priority level assigned to any command
within a selected view.
System view
copy
Use the copy command to copy a file.
User view
copy configuration
Use the copy configuration command to copy the configuration of a specific port to other ports, to ensure
consistent configuration.
System view
count
Use the count command to configure the packet sending times in each test.
Remote-Ping Test Group view
crp-policy
Use the crp-policy command to limit the range of legal C-RP, as well as target service group range of each
C-RP, prevent C-RP spoofing.
PIM view
cut connection
Use the cut connection command to disconnect a user or a category of users by force.
System view
data-flow-format
Use the data-flow-format command to configure the unit of data flow sent to TACACS Server.
HWTACACS view
databits
Use the databits command to configure the data bits for the AUX (Console) port to either 7 or 8.
User Interface view