11
8. Connect the Local Power Supply (Optional)
If the network does not support PoE, you can use the optional local power
supply. To connect the local power supply to the NJ2000, follow these steps:
1 Connect the round connector of the local power supply to the NJ2000 (as
shown in the next diagram).
2 Plug the power cord of the local power supply into an AC outlet.
WARNING: Use only the local power supply available from 3Com. Failure to
do so may result in damage to the NJ2000 or may result in a hazardous
situation.
To Next Page
Loading...
Need help?
General