9
4. Attach the Wall-Mount Bracket
Attach the included wall-mount bracket to the wall opening as shown in this
diagram.
5. Set Up the Network Cabling
The network cabling (from the wiring closet to the wall opening) may already
be installed. If it is not, install the cabling following these general guidelines.
CAUTION: 3Com recommends that a professional cable installer perform
these procedures. Be sure to adhere to local safety and regulatory codes
during the cable installation.
1 Connect one end of an Ethernet cable to the network. Usually, this
connection is made in a network wiring closet, via the patch panel.
2 Terminate the other end of the cable at the location where the NJ2000 is
being installed (using either a female or male RJ-45 connector). Refer to
the connector manufacturer's instructions for terminating the cable. Be
sure to test the connector and verify that it is working.
To Next Page
Loading...
