164 CHAPTER 13: CONFIGURING QUALITY OF SERVICE
Defining CoS The CoS Setup Page contains information for enabling QoS globally.
Monitor users have no access to this page.
To configure CoS Settings:
1 Click Device > QoS > CoS Setup. The CoS Setup Page opens:
Figure 78 CoS Setup Page
The CoS Setup Page contains the following fields:
■ QoS Mode — Specifies if QoS is enabled on the device. The possible
values are:
■ Disable — Disables QoS on the device.
■ Enable — Enables QoS on the device.
■ Select Port(s) — Selects the ports to be configured.
■ Set Default — Sets the default user priority. The possible field values
are 0-7, where 0 is the lowest and 7 is the highest priority.
■ Restore Default — Restores the device factory defaults for CoS
values.
2 Define the fields.
3 Click . CoS is configured on the device, and the device is
updated.
To Next Page
Loading...
