18 CHAPTER 1: INTRODUCING THE ROUTER 3000 DSL FAMILY
■ 9. G.SHDSL port
System specifications
LEDs
There are eight LEDs on 3033 cover. The following table explains their meaning.
Port attributes
3033 Router provides console port, 10/100M Ethernet port, ISDN S/T port and
G.SHDSL port. The following table describes the attributes of G.SHDSL port.
Table 9 System specifications of Router 3033
Item
3033
description
Port 1 console port
1 G.SHDSL port (Standard)
Four 10/100M Ethernet ports
Processor MPC859 50 Mhz
SDRAM 64MB
Flash memory 8MB
Maximum power 12W
Power supply consumption Input Rated voltage: 100-240V a.c., 50/60Hz
Maximum tolerance: 90-264V a.c., 50/60Hz
Current: 0.5A~1A
Output Voltage: 12V d.c
Current: 4A
Dimensions (WxHxD) 300mm (11.81in) X 180mm (7.1in) X 45mm
(1.77in) (Maximum dimensions, which are
the highest arc points of the plastic panel.)
Weight 1kg
operating temperature 0 to 40*C
Operating humidity 10 to 90% (noncondensing)
Table 10 LEDs of Router 3033
LED Description
LAN0/LAN1/LAN2/LAN3 OFF means that link is not set up.
ON means that link has been set up. Blinking means that data is being sent from or
received at the interface.
ADSL ACT OFF means that no data is being sent from or
received at the interface.
Blinking means that data is being sent from
or received at the interface.
ADSL LNK
OFF means G.SHDSL is inactive. ON means G.SHDSL is active.
Blinking means the interface is being trained. SYS
Blinking means that the system is properly
working.
Always ON or OFF means that the system is
incorrectly working
PWR OFF means that power is not being supplied.
ON means that power is being supplied.
To Next Page
Loading...
