26 CHAPTER 4: CONFIGURING THE ROUTER
Figure 4-2New connection
2 Set the terminal parameters
Parameters of the HyperTerminal of Windows 98 are set as follows:
a Select a connection port
Select the serial interface to be connected in the Connect Using box. The
selected serial interface should be the same port as that the console cable
connects.
b Set the serial interface parameters. As shown below, in the properties dialog
box of the serial interface, set the baud rate to 9600, data bit to 8, parity to
none, stop bits to 1 and flow control to none, and click the <OK> button to
return to the HyperTerminal interface.
To Next Page
Loading...
