28 CHAPTER 4: CONFIGURING THE ROUTER
Figure 3 Setting terminal type
Powering on the Router Checking before power-on
Check before powering on the router to ensure that:
■ Power cord and ground wire are correctly connected.
■ Proper power supply voltage is used.
■ The console cable is correctly connected, and configuration PC or console
terminal has been started and the parameters involved have been set.
Locate the emergency power-off switch in the room where you are working
before powering on the router. Then, if an electrical accident occurs, you can
quickly shut the power OFF.
Powering on the router
Turn on the power switch of the router.
Checking/Operating after power-on
After the router is powered on, perform a check to ensure that:
■ LEDs on the cover are displaying correctly.
■ Refer to the descriptions of LED states when the router is running.
■ The console terminal display is correct.
To Next Page
Loading...
