36 CHAPTER 5: SOFTWARE MAINTENANCE
Figure 1 Send File dialog box
5 Click <Browse>, select the application file to be downloaded, and set the protocol
to Xmodem. Then click <Send>, and the system will pop up the following
interface:
Figure 2 Sending file interface
6 After completing download, the system begins writing to Flash (Flash memory),
then the following information will be displayed in the terminal interface,
indicating that the download has been completed:
Download completed.
Writing to flash memory...
Please wait,it needs a long time.Please wait...
########################################################
Writing FLASH Success.
Please use 9600 bps.Press <ENTER> key to reboot the system.
Restore the baud rate of the configuration terminal to 9600bps as per the prompt
(disconnection and re-dialing are also required here), and then the system start up
normally.
To Next Page
Loading...
