1-7
z If you specify only port type, the command displays information about all ports of the specified type.
z If you specify both port type and port number, the command displays information about the
specified port.
Examples
# Display the configuration information of Ethernet 1/0/1.
<Sysname> display interface ethernet 1/0/1
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0012-a990-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input: 0 packets/sec 0 bytes/sec
Last 300 seconds output: 0 packets/sec 0 bytes/sec
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Input(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Input: 0 input errors, 0 runts, 0 giants, - throttles, 0 CRC
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 1-4 Description on the fields of the display interface command
Field Description
Ethernet1/0/1 current state
Current Ethernet port status: UP, DOWN or
ADMINISTRATIVELY DOWN
IP Sending Frames' Format Ethernet frame format
Hardware address Port hardware address
To Next Page
Loading...
