1-3
display detect-group
Syntax
display detect-group [ group-number ]
View
Any view
Parameters
group-number: Detected group number ranging from 1 to 25.
Description
Use the display detect-group command to display the configuration of the specified detected group or
all detected groups.
Examples
# Display the configuration of detected group 1.
<Sysname> display detect-group 1
detect-group 1 :
detect loop time(s) : 15
ping wait time(s) : 2
detect retry times : 2
detect ip option : and
group state : not detecting
register module num : 0
detect ip count : 1
detect-list ip address next hop
1 202.13.1.55 1.2.3.4
Table 1-1 Description on the fields of the display detect-group command
Field Description
detect-group 1 Detected group number 1
detect loop time(s) Detecting interval, in seconds.
ping wait time(s) Timeout time of a ping operation, in seconds.
detect retry times Number of retries of an auto detect operation.
detect ip option
The logic relationship between the detected
objects in the detected group. It can be and or
or.
group state Current state of the detected group
register module num
Number of registered modules (that is, the
number of the modules utilizing the detected
group.)
detect ip count
Number of the IP addresses contained in a
detected group
detect-list
Sequence number of an IP address contained in
a detected group
To Next Page
Loading...
