2-1
2 EAD Configuration Commands
EAD Configuration Commands
security-policy-server
Syntax
security-policy-server ip-address
undo security-policy-server { ip-address | all }
View
RADIUS scheme view
Parameters
ip-address: IP address of a security policy server.
all: IP addresses of all security policy servers.
Description
Use the security-policy-server command to set the IP address of a security policy server.
Use the undo security-policy-server command to remove one specified or all security policy
server address settings.
You can configure up to eight security policy server addresses in each RADIUS scheme. The
switch only responds to those session control messages that come from authentication server or
security policy server.
Examples
# Set a security policy server address 192.168.0.1 on the switch.
<Sysname>system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme extended
[Sysname-radius-extended] security-policy-server 192.168.0.1
[Sysname-radius-extended] display current-configuration
…
radius scheme extended
primary authentication 1.1.11.29 1812
secondary authentication 127.0.0.1 1645
To Next Page
Loading...
