1-17
Fabric name is fab, system mode is L3.
Fabric authentication : no authentication, number of units in stack: 1.
Unit Name Unit ID
First 1(*)
First 2
First 8
<Sysname>update fabric test.bin
This will update the Fabric. Continue? [Y/N] y
The software is verifying ...
The result of verification is :
Unit ID Free space(bytes) Enough Version comparison
1 2126848 Y Y
2 2125824 Y Y
8 1439744 Y Y
warning: the verification is completed, start the file transmission [Y/N] y
The fabric is being updated, 100%
The test.bin is stored on unit 1 successfully
The test.bin is stored on unit 2 successfully
The test.bin is stored on unit 8 successfully
Do you want to set test.bin to be running agent next time to boot[Y/N] y
The test.bin is configured successfully
File Attribute Configuration Commands
boot attribute-switch
Syntax
boot attribute-switch { all | app | configuration | web } fabric
View
User view
Parameters
all: Specifies all the files, including app files, configuration files and Web files.
app: Specifies app files.
configuration: Specifies configuration files.
web: Specifies Web files.
fabric: Specifies to apply the configuration to the whole fabric.
Description
Use the boot attribute-switch command to switch between the main and backup attribute for all the
files or a specified type of files. That is, change a file with the main attribute to one with the backup
attribute, or vice versa.
Examples
# Switch the attributes of all the files in the fabric.
<Sysname> boot attribute-switch all fabric
To Next Page
Loading...
