3-18
device-name: File name, in the form of unit[NO.]>flash:, which is used to indicate that the specified file
is stored in the Flash of a specified switch.
Description
Use the xmodem get command to download files from the local device connected with the Console
port of a switch through XModem. This command can be configured only when the device logging onto
a switch through the Console port.
Note that, the communication parameter settings of the Console port of the switch and those of the
serial port of the local device must be consistent and, the interface type of the Console port must be
AUX.
Examples
# Download files through XModem.
<Sysname> xmodem get flash:/config.cfg
**** WARNING ****
xmodem is a slow transfer protocol limited to the current speed settings of the auxiliary
ports.
During the course of the download no exec input/output will be available!
---- ******* ----
To Next Page
Loading...
