3DHISTECH P1000 - Page 33

P1000 SERVICE SOFTWARE MANUAL
11. OBJECTIVE CHANGER
32
SERVICE GUIDE
2. The illustration below can help understand the operation. The IKO coaches of the three objectives are mounted on the horizontal mount moving
together in X direction. Navigation of the unit in X is only allowed if the objective height is already defined in Z, where the Lifting billet does not
collide the Support bar, and the objective is already navigated to this position. You must define this Z value after setting the objective features.
Support bar
Objective mounting (2-
piece, simple)
IKO linear coaches
Horizontal mounting
Contact or meeting surface
Lifting billets