17. From the data above, the software calculates the Gripper single open stage value. Click its button, navigate to the required position by clicking
Go to II and click on the side panel to set this value.
18. Click the Gripper single closed button. To set this value, use a 26mm-wide slide. Start closing the shoes in negative direction until the slide fits in
the V-shaped indent on the shoes. From this position, step -2000µm. The slide must fit precisely in X and Y but must be able to slide in Z between
the shoes. Click on the side panel to set this value.
19. Click the Gripper double open button. Make this adjustment as previously described in step 16. In this case, set the caliper to 57 mm.
20. To set Gripper double closed use a 51,8 mm-wide slide. Make this adjustment as previously described in step 18.
21. If you have managed to define all values, change to the Validation window and click validate to check the results.
To Next Page
Loading...
