3DHISTECH P1000 - Page 83

P1000 SERVICE SOFTWARE MANUAL
14. SLIDE LOADING UNITS
82
SERVICE GUIDE
6.9. Slide end pos Z
This value is calculated automatically from the Start pos Z value. Click the Go to II button, to insert the slide under the support lath. Click
on the side panel to set this value. Navigate the unit -1000µm-t in Z direction. Click Slide back in the Slide operations menu.
The Insert slide menu is now activated where you can navigate, align and insert the slide to the preview unit. Click Slide back to insert the
slide.
Slide back (into magazine)
Slide out manually (from the Gripper)
Slide out (from Stage)