1. Adjusting the unit
1.1. Initialize the unit.
1.2. Select the sample area at the Grab image section, then click the Live view button.
1.3. Click the Slide to preview grab pos button to move the labeled slide under the camera.
1.4. Click Focus position Y, position the Arm so that the sample area fills out most of the selection area.
Caution!
Make sure that the slide is not moved further than the line! Click Save to save the Y coordinate value!
1.5. Click Preview grab pos, and if the slide is positioned correctly at the previous step, the coordinate value must be saved here as well.
1.6. Click the Live view button to stop live image recording, click Label/barcode area button and click Live image recording button again. Now,
the barcode area is visible between the marker/border lines.
1.7. Click the Barcode grab pos button. Move the Arm in Z-direction until the slide edge near the Arm is positioned within the selection area. Save
the coordinates.
1.8. Click the X button to load back the slide.
Note!
The slide can be loaded back to the magazine only if live image is not recorded, otherwise this button is inactive!
To Next Page
Loading...
