To Next PageTo Next Page
Need help?Do you have a question about the 3i Dualnet-6 and is the answer not in the manual?
General| Category | Control Panel |
|---|---|
| Output Voltage | 12 VDC |
| Current Rating | 6A |
| Operating Temperature | -10°C to +50°C |
| Protection | Overload, Short Circuit |
Lists the main features and specifications of the DUALNET-6 control panel.
Details the function of each terminal connection on the control panel.
Explains how to wire hardwire zones using double balance lines for detection.
Explains the meaning of the LED indicators on the control panel keypad.
Details the information displayed on the keypad for various events and statuses.
Describes service buttons on the keypad for triggering alarms like Hold-up, Fire, and Emergency.
Explains the different types of alarm triggers and how the panel responds.
Step-by-step guide to change the end user password for the control panel.
Procedure to change the installer password for the control panel.
Instructions on how to access and enter the control panel's programming mode.
Guide to memorizing telephone numbers for calls or SMS reporting.
Procedure to configure the time delay for exiting the protected area.
Sets the duration for the emergency siren trigger.
Sets the duration for the perimeter siren trigger.
Sets the duration for the motion siren trigger.
Configures if the panel sends arming status updates to the CMS.
Configures reporting of AC power loss events to the CMS.
Configures reporting of low battery events to the CMS.
Assigns zone type (Day/Night/24hr) and sensor type to zones.
Configures zone bypass status and entry delay for zones.
Details sensor codes, their types, and CID display values.
Default configuration values for hardwire and wireless zones.
Procedure to select a zone number for modification.
Assigns a zone number to the keychain transmitter.
Assigns a group number to the keychain transmitter.
Procedure to learn and memorize wireless sensor codes into the panel.
Assigns a group number for memorizing multiple sensors per zone.
Displays date and time of triggered alarm events.
Procedure to set the current hour on the control panel.
Procedure to set the current date on the control panel.
Commands to arm/disarm the panel using SMS messages.
Commands to arm/disarm/listen via phone call.
Procedures for arming (Day/Night) and disarming the panel.
How to arm the panel immediately without exit delay.
Functions of keypad buttons for triggering alarms (Hold-up, Fire, Emergency).
Commands for remote interrogation, including arming, disarming, and settings.
