NA - ENG
March 2017
3M-Matic
™
7000a-7000a3 Pro
Page 18
Figure 6-1
Figure 6-3
Figure 6-5
Figure 6-4
Fasteners
6.1 Uncrating
The envelope attached to shipping
box contains the uncrating instruc-
tions of the machine (Figure 6-1).
Cut straps. Cut out staple positions
along the bottom of the shipping box
(or remove staples with an appro-
priate tool - Figure 6-2). After cut-
ting out or removing the staples,
lift the shipping box in order to clear
the machine (two persons required).
Transport the machine with a fork-
lift truck to the operating position.
Lift the pallet at the point indicated
in Figure 6-3 (weight of machine +
pallet = See Speci cations).
Removal of Pallet
Loosen and remove nuts and brackets
using the open end spanner supplied
in the tool box (Figure 6-4).
A cardboard box is located under
the machine body. Retrieve instruc-
tion manual for additional set-up
procedures. The box also contains
parts removed for shipping, spare
parts and tools (Figure 6-5)
6.2 Disposal of Packaging Materials
The 7000a-7000a3 Pro package is
composed of:
- Wooden pallet
- Cardboard shipping box
- Wooden supports
- Metal xing brackets
- PU foam protection
- PP plastic straps
- Dehydrating salts in bag
- Special bag of laminated polyester/
aluminium/Polyethylene
(sea freight package only)
- Polyethylene protective material
For the disposal of the above
materials, please follow the
environmental directives or the law
in your country.
.
6. Unpacking
Figure 6-2
To Next Page
Loading...
