14
Installation and Set-Up (Continued)
Initial Start-Up of Case Sealer
After completing the "Installation and Set-Up"
procedure, continue through ""Operation" for tape
loading and start-up to be sure case sealer is
properly adjusted to seal boxes.
15. Electrical connection and controls the
electrical control box (with circuit breaker) and
"On/Off" switch is located on the left side of the
machine frame. See Figure 3-1. A standard
three conductor power cord with plug is provided
at the back of the electrical control box for 115
Volt, 60 Hz, 6.4 Amp electrical service. Before
the power cord is plugged into 115 Volt, 60 Hz
outlet, make sure that all packaging materials
and tools are removed from the machine. Do not
plug electrical cord into outlet until ready to
run machine.
Use of an extension cord is not recommended.
However, if one is needed for temporary use, it
must have a wire size of 1.5 mm diameter
[AWG 16], have a maximum length of 30.5 m
[100 feet], and must be properly grounded.
Note - Machines outside the U.S. may be
equipped with 220/240 Volt, 50 Hz systems,
or other electrical requirements compatible
with local practice.
WARNING To prevent shock and fire
hazard: Position extension cord
where it will be out of the way of foot or
vehicle traffic. Extension cord is only for
temporary use do not use for a
permanent installation.
To Next Page
Loading...
