18
4.0 INSPECTION
4.1 INSPECTION FREQUENCY: The 8mm HLL Permanent Horizontal Lifeline must be inspected by the Certifi ed Installer
after installation and at the intervals defi ned in Section 2. Inspection procedures are described in the “Inspection
and Maintenance Log” (Table 2). Inspect all other components of the Fall Protection System per the frequencies and
procedures defi ned in the manufacturer’s instructions.
4.2 INSPECTION RECORDS: Results of each Certifi ed Installer inspection should be recorded on copies of the Inspection and
Maintenance Log. The date for the next required Certifi ed Installer inspection should be recorded on the System Label.
RFID Tag: Some Horizontal Lifeline (HLL) systems are equipped with a Radio Frequency Identifi cation (RFID) Tag.
The RFID Tag can be used in conjunction with a Handheld Reading Device to simplify inspection and inventory control
and provide records for you fall protection equipment. Contact 3M or visit 3M.com/FallProtection for details.
4.3 DEFECTS: If inspection reveals an unsafe or defective condition, do not use the 8mm HLL System. Follow employer
recommended Lockout/Tagout procedures to remove the system from service and contact the 3M Certifi ed Installer for
inspection and service. Do not attempt to repair the system. Only 3M or parties authorized in writing by 3M may make
repairs to this equipment.
4.4 PRODUCT LIFE: The functional life of the 8mm HLL system is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
5.0 MAINTENANCE, SERVICING, STORAGE
5.1 CLEANING: Periodically clean the systems metal components with a soft brush, warm water, and a mild soap solution.
Ensure all components are thoroughly rinsed with clean water after cleaning.
Contaminants: Although highly resistant to chemicals and environmental conditions, avoid contaminating the 8mm
HLL and Travelers with acids, bitumen, cement, paint, cleaning fl uids, etc. If the equipment contacts acids or other
caustic chemicals, remove from service and wash with water and a mild soap solution. Inspect per the “Inspection and
Maintenance Log” (Table 2) before returning to service.
5.2 SERVICE: Only 3M or Certifi ed Installers authorized in writing by 3M Fall Protection may make repairs to this equipment.
If the 8mm HLL System has been subject to fall force or inspection reveals an unsafe or defective conditions, remove the
system from service and contact 3M Fall Protection or a 3M Certifi ed Installer regarding replacement or repair.
To Next Page
Loading...
