37
EN
I cannot control the
system with the
RCU-300.
Make sure there are fully charged batteries in the SCU-300.
Check the battery level of the RCU-300. Refer to “10.4.1. Battery status”.
Pair the SCU-300 to the RCU-300. Refer to “5.1. To pair the RCU-300 to the SCU-300”.
Make sure that you are using the correct RCU-300.
Make sure the RCU-300 is not too far away from the SCU-300.
Do a factory reset of the RCU-300. Refer to “5.1. To pair the RCU-300 to the SCU-300”.
To Next Page
Loading...