3M PELTOR Electronic Earplug EEP-100 - Using the EEP-100 Earplug; Power On and Environmental Listening

9
Note: Whenpoweredoffandproperlytintheearcanal,theearplugswillstillhelpprovide
hearing protection.
Using the EEP-100 earplug
1. Power On: Turn the product on by pressing and holding the power/control button for
2 seconds (Fig. A:1). This is referred to as a “long” press. You may release the button when
you hear a tone. The earpiece should now be on and in the low volume setting. Repeat this
process for the other earpiece.
Note: Whentheearpieceisturnedonandproperlyttedinyourear,soundenteringyourear
shouldnotsounddistant,faint,ormufed.Ifitdoes,makesurethedeviceisturnedon.
2. Environmental Listening: When the earplugs are powered on, the user can adjust the
volume to a comfortable setting by quickly pressing and releasing the power/control button.
This is referred to as a “quick” press. When powered on, the earpieces allow sounds to
pass through in quiet environments while restricting the volume level in loud environments.
Upon power on, the EEP-100 defaults to the low setting, which reproduces the environmental
sounds at a reduced level. Each setting is indicated by a unique tone.
• Audio levels are selectable by pressing the power/control button momentarily.
This cycles through three audio levels: low, medium, and high.
3. Power Off: Press and hold the Power/Control button for two seconds, until a double beep is
heard. Then the button can be released and the earpiece is powered off. Repeat this process
for the other earpiece (Fig. A).
Note: Whenpoweredoffandproperlytintheearcanal,theearplugswillstillhelpprovide
hearing protection.
Attach/Detach Windscreen (not included with EEP-100)
The windscreen may help minimize wind noise in high wind conditions.
Note: For the EEP-100, windscreens may be purchased (see, "Reorder).
1. Remove a disposable windscreen from the perforated windscreen sheet backing (Fig.G:1).
2. Locate the earplug microphone (Fig.G:2).
3. Carefully center the disposable windscreen over the microphone port and press the
adhesive backed windscreen to the microphone port (Fig.G:3).
4. To detach, remove the windscreen and dispose when necessary. To attach, follow steps 1-3.
Note: After storing and/or recharging the earplug in the charging case, it may be necessary to
remove the old disposable windscreen and replace with a new screen.
G:1
Fig. G
G:2
G:3