3M PELTOR SCU-300 - Storage and Disposal; 10.1. Storage Guidelines; 10.2. Disposal Instructions

11
The SCU-300 will not
connect with or operate
the ComTac™ VII and/or
TEP-300.
Make sure there are fully charged batteries in the SCU-300.
Restart the ComTac™ VII and/or TEP-300. For more information see product manuals for
ComTac™ VII and/or TEP-300.
Restart the SCU-300.
Make sure the SCU-300 is correctly tted and aligned with ComTac™ VII. Refer to the manual
for “3M™ PELTOR™ Tactical Modular Audio System”.
Make sure the products in the 3M™ PELTOR™ Tactical Modular Audio System have been
started in the correct order. Refer to the manual for “3M™ PELTOR™ Tactical Modular Audio
System”.
Press and hold the menu button on the SCU-300 for at least 10 seconds or until 2 short beeps
indicates a successful pairing. The headset will indicate “NFMI pairing on”.
Do a factory reset of the SCU-300. Refer to “8.4.19. Factory reset”.
NFMI connection is
unstable.
If several users are placed close to each other, connect your headset to SCU-300 with the
headset cable. Refer to ““6.9. To connect to an external radio”.
I get thrown out of the
menu.
The user automatically exits the menu if no button is pressed for 10 seconds.
I cannot control the system
with the RCU-300.
Make sure there are fully charged batteries in the SCU-300.
Check the battery level of the RCU-300. Refer to “8.4.1. Battery status”.
Pair the SCU-300 to the RCU-300. Refer to “6.6. To pair the RCU-300 to the SCU-300”.
Make sure that you are using the correct RCU-300.
Make sure the RCU-300 is not too far away from the SCU-300.
Do a factory reset of the RCU-300. Refer to “6.4. To power on the RCU-300”.
EN
10. STORAGE AND DISPOSAL
10.1. STORAGE
• Clean the product before storage.
• Examine the product for wear or damage.
• Keep the product in a clean and dry area within a
temperature range of: -20°C/-4°F to 50°C /122°F.
• Do not put the product in sunlight during storage.
• During long term storage, remove the batteries from
the battery holder.
10.2. DISPOSAL
• Obey national regulations.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
• Use the local recycling system for electronic equipment.
• This product contains electrical and electronic components
and must not be disposed of using standard refuse
collection. Please consult local directives for disposal of
electrical and electronic equipment.