3M SCOTT AIR-PAK X3 PRO - Inspecting the Regulator

SOFT GOODS ASSEMBLY & DISASSEMBLY
26 P/N 595360-01 Rev G 202004
2 Unsnap the drag rescue loop from the shoulder pad. See Figure 2-2.
Figure 2-2 Unsnapping the drag rescue loop from the shoulder pad
3 At the top of the shoulder harness, unsnap the straps securing the
cable, gaugeline, and regulator hose. See Figure 2-3.
4 Move the cable, gaugeline, and regulator hose to their respective
sides.
Figure 2-3 Unsnapping the top strap securing the cable, gaugeline, and regulator hose
5 Remove the lower cable routing clamp from the shoulder pad webbing by folding the edges of the webbing
together to form a “V” and sliding the edges through the clamp opening. See Figure 2-4.
Figure 2-4 Removing the lower cable routing clamp
NOTE
The snap at the top of the shoulder harness is a directional
snap fastener. To open (unsnap), lift the edge with the dot.
Do not use a tool or excessive force to engage or
disengage the snaps.
Drag rescue loop
Top snap
Lower cable
routing clamp
Fold the
webbing to form
a “V”