ATTACHING THE SHOULDER HARNESS AND WAIST PAD
P/N 595360-01 Rev G 202004 35
6 Attach the UEBSS or dual EBSS pouch to the waist pad.
a Secure the UEBSS or dual EBSS hose into place by snapping the retaining strap. Coil the hose and fit it into the
pouch. See Figure 2-21.
Figure 2-21 A) Securing the UEBSS or dual EBSS hose. Coiling the hose and fitting the hose into the pouch for B) UEBSS and C) dual EBSS.
b Snap the fasteners on the flap to close the pouch.
c Locate the strap on the back of the pouch and slide it under the waist pad webbing and fasten the snaps. See
picture A in Figure 2-22.
d Feed the waist-to-shoulder strap through the loop in the UEBSS or dual EBSS pouch. See picture B in
Figure 2-22.
NOTE
The snaps attaching the waist pad retaining strap and waist pad are directional snap fasteners. To snap
closed, align the two sides of the fastener and press from the end opposite the dot toward the end with the
dot until you hear a “snap.” Do not use a tool or excessive force to engage or disengage the snaps.
A
B
C
To Next Page
Loading...
