SOFT GOODS ASSEMBLY & DISASSEMBLY
36 P/N 595360-01 Rev G 202004
Figure 2-22 A) Fastening the snaps attaching the UEBSS or dual EBSS pouch to the waist pad. B) Attaching the waist-to-shoulder straps.
To attach the shoulder harness to the backframe
1 Pass the lower metal slide and webbing through the lower slot of the clevis (see Figure 2-23). Lift the shoulder
pads and orient the metal slide at an angle to help it pass through the slot.
Figure 2-23 Passing the lower metal slide through the lower slot of the clevis
2 Pass the drag rescue loop through the upper slot of the clevis.
a Align the snaps on the loop with the center of the slot and carefully pull the loop through the slot, taking care
not to damage the snaps. See picture A in Figure 2-24.
b Flatten the metal slide and pass it through the upper slot. Lift the shoulder pads to help the slide pass through
the slot. See picture B in Figure 2-24.
A B
Feed strap through
loop on UEBSS or dual
EBSS pouch
Clevis
To Next Page
Loading...
