P/N 595373-01 Rev C 202004
37
CHAPTER 4
CLEANING & STORING THE RESPIRATOR
This chapter provides instructions for cleaning and storing the 3M Scott Air-Pak X3 Pro SCBA. Detailed instructions
for cleaning the facepiece and mask-mounted regulator are also provided.
• “Before You Begin” on page 37
• “Cleaning the Respirator” on page 37
• “Cleaning the Facepiece” on page 38
• “Cleaning the Mask-Mounted Regulator” on page 39
• “Cleaning the Shoulder Harness and Waist Pad” on page 41
• “Storing the Respirator” on page 41
Before You Begin
Carefully read “Safety Information” on page ix before beginning any of the procedures in this chapter.
After using the respirator, clean it according to these instructions and perform a regular operational inspection as
outlined in “Chapter 2: Inspecting the Respirator” on page 5. If you find any damage, remove the respirator from
service and tag it for repair by authorized personnel.
Prior to handling or using any of the cleaning agents mentioned in this instruction, please consult the manufacturer’s
Material Safety Data Sheet (MSDS) for precautions and important instructions.
Cleaning the Respirator
To clean the respirator
1 Using a damp sponge, wipe any accumulated dirt from the exterior of the respirator.
2 Clean the facepiece and mask-mounted regulator as described in “Cleaning the Facepiece” on page 38 and
“Cleaning the Mask-Mounted Regulator” on page 39.
You can remove the shoulder harness and waist pad assemblies for decontamination or laundering as described in the
3M Scott Air-Pak X3 Pro Inspection and Cleaning Instructions (P/N 595360-01).
TIP
The light sensor for the HUD brightness control is located on the front of the remote gauge housing. Be sure
to clean the front of the remote gauge housing to enable proper functioning of the sensor.
202004
P/N 595373-01
Rev C
To Next Page
Loading...
