NP301 Serial Device Server
Quick Installation Manual
3onedata Co., Ltd.
Address:
3/B, Zone 1, Baiwangxin High Technology
Industrial Park, Xili, Nanshan District, Shenzhen
【Package Checklist】
Please check whether the package and accessories are intact
while using the serial device server for the first time.
Straight-through cable × 1
If any of these items are damaged or lost, please contact our
company or dealers, we will solve it ASAP.
【Product Overview】
This product is a serial device server. Model as follow: NP301
(Single Ethernet, 1-port RS-232 or RS-485/422)
【Panel Design】
Top view
Side view and front view
Bottom view
1. RS-485/422 serial port
2. RS-232 serial port
3. Ethernet port link/act indicator
4. Serial port transmission or receive data indicator
5. Power supply status indicator
6. Wall mounting kit
7. 10/100Base-T(X) copper port
8. Restore factory settings button
9. Terminal block for power input
【Mounting Dimension】
Unit: mm
Note Before Mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running,
please don't directly contact to avoid scalding.
【Wall Mounting】
Mounting the Device
On the wall of device mounting, place the device on Step 1
the wall for reference or reference the mounting
dimension to mark two screw position.
Nail two M4 screws on the wall and keep 2mm Step 2
interspace reserved.
Hang the device on two screws and slide Step 3
To Next Page
Need help?
General
