04
Step 4. Managing cables
1. Managing the Type-C connecting cable
Route the Type-C connecting cable along the A
pillar, top of the windshield to the main device.
You can use the wiring crowbar to hide the
cable underneath the vehicle’s headliner and
rubber seal along the A-pillar.
2. Managing the hardwire kit
Route the hardwire kit along the gap between
the console center and the A pillar to the fuse
box.
If the hardwire kit is too long, tie it up, but do
not cut it. Cutting the hardwire kit will affect the
power and ACC signal to the main device.
sleep mode, restart the engine and check if
the main device automatically turns on.
If the above steps can be proceed correctly,the
circuit and ACC signal test is passed.
If the circuit and ACC signal test fails, please
check the wiring of the hardwire kit and
ensure that the fuse and ground are correctly
connected.
If the connection is correct, but the test fails,
contact after-sales service for assistance.
To Next Page
Loading...
