User Manual NUVOLAS
April 2023
File: User Manual_NUVOLAS_rev3.docx 9
2 Transport and Storage
We at A.R.C. Laser GmbH will make sure that the device is packed and transported with
the greatest possible care.
Before unpacking the laser, please check the packaging for damage and report any
damage immediately to the shipping agent and A.R.C. Laser GmbH. Only remove the
packaging in the presence of a representative of the carrier. Make a list of the damaged
parts and have this list signed by the courier.
The device must be transported at temperatures between -10° C and +60° C. The air
pressure during transport must be between 1080 hPa and 750 hPa. During storage, a
temperature range of -10° C to 60° C must be maintained. The environment/air must be
dry and clean. The relative humidity during transport and storage must be below 85 %.
2.1 Shipping and unpacking the device
Unpacking and installation of the device will be carried out by an authorized technician or
authorized representative of A.R.C. Laser GmbH. After the installation and the correct
connection of the device, the technician will put the device into operation and explain the
function of the device. All functions and safety procedures are discussed and
demonstrated here.
A T T E N T I O N
If the laser is transported or stored in temperatures below -10° C, it can be damaged
when starting. Unpack the laser and leave it at least eight hours at normal room
temperature so that the system reaches room temperature.
To Next Page
Loading...
Need help?
General