loudspeaker connection terminal on the receiver or amplifier. The black terminal on the
loudspeaker should be connected to the black or (-) loudspeaker connecation terminal on the
receiver or amplifier. Connecting the loudspeakers in this manner ensures that they will be in
phase; that is work together rather than in opposition. Connecting the loudspeakers out of
phase will not damage them, but will result in less bass and poor imaging. (Fig.1)
Home Theater Application
Adding center and rear speakers to the left and right channels will enhance the surround
effects of motion pictures. If you choose smaller models, an active sub-woofer is essential
for adequate bass reproduction.
You will need one pair of cable for each speaker in the system.
On the back panel of your AV amplifier, locate the Front Speaker, Center Speaker, and
Rear Speaker terminals.
Using the same method as connecting two channel stereo speakers, connect left and right,
center, and rear speakers to the corresponding terminals on the AV amplifier. Again, be
sure to match the speaker cables to the appropriate terminals on the components: (+) to (+)
and (-) to (-) to ensure sufficient bass and clear imaging.
-4-
FIG. 1
++
__
S-160 Powered Subwoofer
Owner's Information
Important Instructions
1. Read your owner's manual carefully before using the product. Retain this manual
for future reference.
2. The subwoofer should be placed at a ventilated, dry and cool location, away from
any heat sources such as radiators or amplifiers. Do not obstruct the subwoofer
amplifier from ventilation. It is necessary that air can flow around the rear panel of
the amplifier.
To Next Page
Loading...